System information

BSR 64000 Configuration and Management Guide
9-44
Gathering RIP Information
Follow these steps to monitor RIP on the BSR:
1. To display RIP routes and the status of each rip route on the BSR interface, use
the show ip route rip command in Privileged EXEC mode as shown in the
following example:
MOT#show ip route rip
2. To display the configured network parameters for RIP, use the show ip protocols
in Privileged EXEC mode, as shown in the following example:
MOT#show ip protocols
Figure gives an example of the show ip protocols command output:
Figure 9-2 show ip protocols Command Output
3. To display the entire contents of the private RIP database when triggered
extensions to RIP are enabled, use the show ip rip database command in
Privileged EXEC mode, as shown in the following example:
MOT#show ip rip database
4. To view the routing table, enter the show ip route command in Privileged EXEC
mode, as shown in the following example:
MOT#show ip route