System information

BSR 64000 Configuration and Management Guide
8-10
1. Use the router dvmrp command in Router Configuration mode to enter Router
Configuration mode from Global Configuration mode, as shown below:
MOT(config)#router dvmrp
2. Use the network command in Router Configuration mode to define the network
IP address and subnet mask for the DVMRP network:
MOT(config-dvmrp)#network <ip-address> <wild-card>
where:
ip-address is the IP address of the DVMRP network.
wild-card is the wild-card mask for the DVMRP network.
Configuring the DVMRP Route Expiration Threshold
Use the route expire-interval command in Router Configuration mode to set the
DVMRP route expiration interval, as shown below:
MOT(config-dvmrp)#route expire-interval <n>
where:
n is the route expiration interval from 5 to 3600 seconds.
Configuring the DVMRP Route Reporting Threshold
Use the route report-interval command in Router Configuration mode to set how
often DVMRP routes are reported, as shown below:
MOT(config-dvmrp)#route report-interval
where:
n is the route reporting interval from 5 to 3600 seconds.
Limiting the Number of DVMRP Routes
Seven-thousand DVMRP route reports can be advertised on the BSR by default. Use
the route-limit command in Router Configuration mode to change the number of
DVMRP route reports that can be advertised per interval on the BSR, as shown
below: