System information

BSR 64000 Configuration and Management Guide
8-8
n is the interval from 1 to 200 seconds.
If you want to configure a candidate RP that is associated with this router, use the
ip pim rp-candidate ip-address command, as shown below:
MOT(config-if)#ip pim rp-candidate ip-address <ip-address>
where:
ip-address is an IP address of the candidate RP.
The RP candidate priority is 0 by default. If you want to use the RP candidate
priority for the router, use the ip pim rp-candidate priority command, as shown
below:
MOT(config-if)#ip pim rp-candidate priority <n>
where:
n is the assigned priority of the candidate RP from 0 to 255.
Modifying the PIM Router-Query Message Interval
Router-query messages are used to elect a PIM designated router. The designated
router is responsible for sending PIM join and PIM register packets. By default,
multicast routers send PIM router-query messages every 60 seconds. To modify this
interval, use the following command in interface configuration mode:
MOT(config-if)#ip pim query-interval <n>
where:
n is the number of seconds from 0 to 65535 that multicast routers send PIM
router-query messages
Configuring DVMRP
Use the following sections to learn how configure the Distance Vector Multicast
Routing Protocol (DVMRP) on the BSR: