System information

BSR 64000 Configuration and Management Guide
6-124
• To display the number of Customer Premises Equipment (CPE) hosts connected
to a specific CM, use the show cable modem hosts command in Privileged
EXEC mode, as shown below:
MOT#show cable modem {<mac> | <prefix>} hosts
where:
mac is the CM MAC address.
prefix is the CM IP address.
Figure 6-19 displays the current number of hosts connected to the CM.
Figure 6-19 show cable modem hosts Command Output
• Use the show cable modem offline command to display offline CMs only, as
shown below:
MOT#show cable modem offline [<mac> | <0-15>]
where:
mac is the MAC hardware address of the CM.
0-15 is the slot number of the cable module to which CMs are associated.
Figure 6-20 displays the current number of offline CMs.
Figure 6-20 show cable modem offline Command Output
Note: The show cable modem offline command output is updated if the aging
timer interval expires for an offline CM. Also, the CM offline table can contain
6100 entries. If this total number is reached and a new CM goes offline, the
oldest entry in the table is deleted.