System information

BSR 64000 Configuration and Management Guide
6-114
Displaying Downstream Parameters
To show the configured parameters for the downstream port, use the show cable
downstream command in Interface Configuration mode, as shown below:
MOT(config-if)#show cable downstream <0-0>
where:
0-0 is the downstream port number.
Figure 6-10 displays the show cable downstream command output:
Figure 6-10 show cable downstream Command Output
Viewing Downstream Port Information
Use the show interfaces cable downstream command in all modes except User
EXEC mode to view downstream port statistics, as shown below:
MOT#show interfaces cable <x>/<y> downstream <0-0>
where:
x is the slot number of the cable module.
y is the cable interface number, which is 0.
port is the downstream port number.