System information

Configuring the CMTS
6-89
The following example shows that upstream port 1 on module 0 has a MIB Index ID
number (ifIndex) of 5. This number is used to determine the slot and upstream port
number that is displayed in the debug specmgr and console logging output.
MOT(config)#interface cable 0/0
MOT(config-if)#show cable upstream 1
ifIndex: 5
centerFreq: 13200000
rng_back_st: 0
rng_back_en: 4
data_back_st: 2
data_back_en: 8
channelWidth: 3200000
powerLevel: 100
slotSize: 4
force-frag: 0
map-interval: 4000
pre-equalization: 0
invited-range-interval: 10000
range-forced-continue: 0
range-power-override: 0
physical-delay: Mode 0, Min 1600, Max 1600
rate-limit: 0
modulation-profile: 2
Spectrum Group: spectrum_1
Viewing Spectrum Management Activity
The logging console notifications command can be used to monitor spectrum
management activity whenever the frequency, channel width, modulation profile,
power level changed manually or changed by the Spectrum Manager, the notification
message is displayed.
Use the logging console notifications command in Global Configuration mode to
turn on console logging and view manual changes or changes made by the spectrum
manager, as shown below:
MOT(config)#logging console notifications