System information

BSR 64000 Configuration and Management Guide
6-88
For example, Figure 6-6 displays a typical signal-quality result for an upstream port:
Figure 6-6 show interfaces cable upstream signal-quality Command Output
Determining the MIB Index ID Number of an Upstream Port
It is important to learn the MIB Index ID number that is associated to a specific
upstream port on a DOCSIS module because the debug specmgr and logging console
notifications command log output only displays the MIB Index ID number.
Follow these steps to determine the MIB Index ID number of an upstream port:
1. Use the interface cable command to enter the desired cable interface, as shown
below:
MOT(config)#interface cable <x>/<y>
where:
x is the slot number of the cable module.
interface is the cable interface number, which is 0.
2. Use the show cable upstream command to discover what MIB Index ID number
is associated with a upstream port on a particular module as shown below:
MOT(config-if)#show cable upstream <NUM>
where:
NUM is the upstream port number.