System information

BSR 64000 Configuration and Management Guide
6-86
Figure 6-4 displays the show interface cable upstream spectrum command
output:
Figure 6-4 show interface cable upstream spectrum Command Output
Viewing Spectrum Management Configuration Changes
Follow these steps to view upstream information when the spectrum manager makes
changes to an upstream port:
1. Use the interface cable command to enter the desired cable interface, as shown
below:
MOT(config)#interface cable <x>/<y>
where:
x is the slot number of the cable module.
y is the cable interface number, which is 0.
2. Use the show cable upstream command to look the current frequency, channel
width, modulation or power level for the upstream port:
MOT(config-if)#show cable upstream <NUM>
where:
NUM is the upstream port number.