System information

BSR 64000 Configuration and Management Guide
6-74
3. Use the hop action modulation-profile command in Cable Spectrum Group
mode to change the modulation profile setting for a hop action, as shown below:
MOT(config-spcgrp:<WORD>)#hop action modulation-profile {<1-16>}
[priority {<1-255>}]
where:
WORD is the spectrum group name.
1-16 is the modulation profile number. The default modulation profiles are 1
and 2.
1-255 is the priority number of the upstream modulation profile hop action.
When no priority is assigned, the default priority is 128.
For example, the following syntax determines that modulation profile 2 replaces
the existing modulation profile when the hop action is triggered and defines the
priority level of the hop:
MOT(config-spcgrp:spectrum1)#hop action modulation-profile 2
priority 50
Note: Refer to the Creating a Modulation Profile section for more information
on configuring modulation profiles.