System information

BSR 64000 Configuration and Management Guide
6-68
Scheduling the Removal of a Spectrum Group Band
Follow these steps to schedule the removal of a spectrum group band:
1. Use the cable spectrum command in Global Configuration mode to enter Cable
Spectrum Group mode, as shown below:
MOT(config)#cable spectrum <WORD>
where:
WORD is the spectrum group name.
The Cable Spectrum Group mode displays for the spectrum group.
2. If you want to schedule the time when the spectrum group band is removed on a
daily basis, use the time delete band command in Cable Spectrum Group mode,
as shown below:
MOT(config-spcgrp:<WORD>)#time <hh:mm:ss> delete band {<start
frequency> <end frequency>}
where:
WORD is the spectrum group name.
hh:mm:ss is the time during the day when the band is removed.
start frequency is the start upstream frequency from 5000000 to 42000000
Hertz.
end frequency is the end upstream frequency from 5000000 to 42000000
Hertz.
The following example determines that the band from 25 MHz to 35 MHz,
belonging to spectrum group spectrum1, is removed every day at 20:00 PM:
MOT(config-spcgrp:spectrum1)#time 20:00:00 delete band 25000000
35000000
Note: If a new removal time for a band is entered for a spectrum group, the
existing removal time for a band must be deleted first.