System information

BSR 64000 Configuration and Management Guide
6-64
For example, if you defined your spectrum1 group to have a start frequency of 8
MHz and an end frequency of 12 MHz your command syntax would look as
shown below:
MOT(config-spcgrp:spectrum1)#band 8000000 12000000
• If you need to add another start and end frequency band to the spectrum
group, repeat this step.
• If you need to delete a start and end frequency band from a spectrum group,
use the no band command as shown below:
MOT(config-spcgrp:<WORD>)#no band {<start frequency> <end
frequency>}
Scheduling the Availability of a Spectrum Group Band
The time band command is used to schedule when a spectrum group band is
available. The spectrum group band can be made available on either a daily or weekly
schedule.
Follow these steps to schedule the availability of a spectrum group band:
1. Use the cable spectrum command in Global Configuration mode to enter Cable
Spectrum Group mode, as shown below:
MOT(config)#cable spectrum <WORD>
where:
WORD is the spectrum group name.
The Cable Spectrum Group mode displays for the spectrum group.
Note: If a new availability time for a band is entered for a spectrum group, the
existing availability time for a band must be deleted first.