System information

BSR 64000 Configuration and Management Guide
6-62
Defining a spectrum group contains the following tasks outlined in this section:
• Creating a Spectrum Group
• Scheduling the Availability of a Spectrum Group Band
• Scheduling the Removal of a Spectrum Group Band
• Configuring Spectrum Data Collection
• Configuring Spectrum Hopping Rules
• Configuring the Spectrum Hopping Error Threshold
• Configuring the Spectrum Hopping Flap Threshold
• Enabling and Disabling Spectrum Roll-back
• Configuring the Guard Band
• Reviewing the Spectrum Group that You Created
Creating a Spectrum Group
Follow these steps to create a cable spectrum group:
1. To create a cable spectrum group and enter the new mode in which to configure
your cable spectrum group, use the cable spectrum command in Global
Configuration mode, as shown below:
MOT(config)#cable spectrum <WORD>
where:
WORD is the spectrum group name.
Note: No spaces are allowed for the spectrum group name.