System information

BSR 64000 Configuration and Management Guide
6-58
• The cable interface uses a downstream classifier to assign packets to downstream
service flows.
• The CM uses an upstream classifier to assign packets to upstream service flows.
To display the packet classifiers of a service flow configured on the cable interface,
use the show cable qos svc-flow classifier command in Privileged EXEC mode, as
shown below:
MOT#show cable qos svc-flow classifier {<x>/<y>} [<1-4292967295> | <cr>]
[<1-65535> | <cr>]
where:
x is the slot number of the cable module.
y is the cable interface number, which is 0.
1-4292967295 is the Service Flow Identifier (SFID).
cr is a command return, which displays QoS service flow statistics for all SFIDs.
classifier-id is the classifier identifier..
Note: If the Classifier ID is not given, all the classifiers with the given SFID
are listed.