System information

BSR 64000 Configuration and Management Guide
6-56
3. To display service flow statistics, use the show cable qos svc-flow statistics
command in Privileged EXEC mode, as shown below:
MOT#show cable qos svc-flow statistics {<x>/<y>} {<1-4292967295> | <cr>}
where:
x is the slot number of the cable module.
y is the cable interface number, which is 0.
1-4292967295 is the Service Flow Identifier (SFID) number.
cr is a command return, which displays QoS service flow statistics for all
SFIDs.
4. To display statistics for both upstream and downstream DSC messages, use the
show cable qos svc-flow dynamic stat command in Privileged EXEC mode, as
shown below:
MOT#show cable qos svc-flow dynamic stat
Initiating a DSD
Use DSD messages to delete an existing service flow. Follow these steps to delete a
specific service flow:
1. To display the SFID of all the service flows used by a specific CM, use the show
cable modem svc-flow-id command in Privileged EXEC mode, as shown below:
MOT#show cable modem [<mac> | <prefix>] svc-flow-id
where:
mac is the CM MAC address.
prefix is the CM IP address.
Note: Before you begin, ensure that the correct CM SFID is selected.