System information

BSR 64000 Configuration and Management Guide
6-54
Setting QoS Parameters
This section describes how to configure Quality of Service (QoS) using service flows.
Use the commands in this section to create, change, or delete service flows with
Dynamic Service Addition (DSA), Dynamic Service Change (DSC), and Dynamic
Service Deletion (DSD) MAC management messages. Configuring QoS involves the
following tasks:
• Initiating a DSA
• Initiating a DSC
• Initiating a DSD
• Viewing QoS Information
Initiating a DSA
Use a DSA message to create a new service flow. The cable interface initiates a DSA
for a specified CM.
1. To create a new service flow, use the cable modem qos dsa command in
Privileged EXEC mode, as shown below:
MOT#cable modem {<mac> | <prefix>} qos dsa {<prefix> <string>}
where:
mac is the CM MAC address.
prefix is the CM IP address.
prefix is the TFTP server IP address.
string is the CM configuration file name.
Note: Before you begin, ensure that the correct DSA definition is entered in
the CM configuration file.