System information

BSR 64000 Configuration and Management Guide
6-48
Denying Access to a Cable Modem
Use the cable modem deny command in Privileged EXEC mode to remove a
specified cable modem from the network and deny it future entry, as shown below:
MOT#cable modem deny <mac>
where:
mac is the MAC address of the cable modem.
Use the no cable modem deny command to remove the restriction from the specified
cable modem, as shown below:
MOT#no cable modem deny <mac>
where:
mac is the MAC address of the cable modem.
Setting the Maximum Number of Hosts
Use the cable modem max-hosts command to set the number of CPE hosts that can
connect to a CM on the HFC subnetwork.
1. To specify the maximum number of CPE hosts that can attach to a CM, use the
cable modem max-hosts command in Privileged EXEC Mode, as shown below:
MOT#cable modem [<mac> | <prefix>] max-hosts <0-32>
where:
mac is the CM MAC address.
prefix is the CM IP address.
0-32 is the maximum number of hosts.