System information

BSR 64000 Configuration and Management Guide
6-44
Enabling the CM Aging Timer
The cable modem (CM) aging timer feature is disabled by default. The CM aging
timer feature is used to automatically remove off-line CMs from the network after a
configured time period.
Use the cable modem-aging-timer command in Global Configuration mode to set
and enable the CM aging timer, as shown below:
MOT(config)#cable modem-aging-timer {<10-30240>}
where:
10-30240 is the CM Aging Timer number in minutes (10 minutes to 21 days).
Use the cable modem-aging-timer off command to disable the aging timer.
Setting the Insertion Interval for CMs
The insertion interval is the fixed time period available for CM initial channel request.
The default insertion interval is 20.
1. To set the insertion interval for CM initial channel request, use the cable
insert-interval command in Interface Configuration mode, as shown below:
MOT(config-if)#cable insert-interval {<0-200>}
where:
0-200 is the insertion interval.
2. To return the default insertion interval, use the no cable insertion-interval
command in Interface Configuration mode, as shown below:
MOT(config-if)#no cable insert-interval {<0-200>}
where:
Note: Ensure that the upstream port is down before setting the insertion
interval.