System information

BSR 64000 Configuration and Management Guide
6-18
2. To enable the downstream port again, use the no cable downstream shutdown
command in Interface Configuration mode, as shown below:
MOT(config-if)#no cable downstream shutdown
3. To verify that the downstream port is activated, use the show interface cable
command in Privileged EXEC
mode, as shown below:
MOT#show interfaces cable 0
Reserving Downstream Bandwidth
To reserve a specified amount of downstream bandwidth for CMs, use the cable
downstream reserve-bandwidth command, in Interface Configuration mode, as
shown below:
MOT(config-if)#cable downstream <0-0> reserve-bandwidth <1-38469736>
where:
port is the downstream port number.
1-38469736 is the amount of downstream bandwidth in bits per second.
Unreserving Downstream Bandwidth
To unreserve a specified amount of downstream bandwidth for CMs, use the cable
downstream unreserve-bandwidth command, in Cable Interface mode, as shown
below:
MOT(config-if)#cable downstream <0-0> unreserve-bandwidth
<1-38469736>
where:
0-0 is the downstream port number.
1-38469736 is the amount of downstream bandwidth in bits per second.