System information

BSR 64000 Configuration and Management Guide
4-8
Enabling SNMP
To configure SNMP, enable the SNMP server using the snmp-server enable
command, as shown below:
1. Use the snmp-server enable command in Global Configuration mode to enable
SNMP Server operation with traps, or informs, as shown below:
MOT(config)#snmp-server enable {informs | traps}
where:
informs enables SNMP Informs.
traps enables SNMP Traps.
2. Disable SNMP using the snmp-server shutdown command, as shown below:
MOT(config)#snmp-server shutdown
This command disables the SNMP Agent running on the server.
Configuring SNMPv3
This section describes the procedure to configure the SNMP Agent to receive,
process, and respond to SNMPv3 packets. The procedure includes configuring the
following:
Note: Different SNMP versions can coexist.
Note: You can also enable the SNMP Agent by issuing any SNMP
configuration command.