Network Router User Manual

BSR 2000 Command Reference Guide Release 1.0
1-56 MGBI 526363-001-00 Rev. B
ip tftp source-interface loopback
The ip tftp source-interface loopback command allows an operator to control the
source IP address of TFTP packets generated by the BSR by
specifying a loopback
interface as the source IP address for TFTP packets.
The normal convention for
generated TFTP packets is to set the source IP address equal to the IP address of the
outgoing interface. The ip tftp source-interface loopback command overrides this
convention and instead uses the IP address of the specified loopback interface. The no
ip tftp source-interface loopback command removes the loopback source interface.
Group Access
System Administrator
Command Mode
Global Configuration
Command Line Usage
ip tftp source-interface loopback <1-64>
no ip tftp source-interface loopback
Command Syntax
Note: Before using the ip tftp source-interface loopback command, the
loopback interface must be configured and assigned an IP address.
1-64 the loopback interface number