Network Router User Manual

Release 1.0 System Administration Commands
526363-001-00 Rev. B MGBI 1-39
duplex
The duplex command configures an Ethernet interface for duplex mode (full or half)
and enables/disables auto-negotiation
Group Access
ISP
Command Mode
Interface Configuration (Ethernet interface only)
Command Line Usage
duplex {half | full | auto}
no duplex {half | full | auto}
Command Syntax
Command Default
Auto negotiation enabled
half configures the interface for half-duplex
operation. Half-duplex operation allows the
interface to send and receive signals, but not
at the same time.
full configures the interface for full-duplex
operation. Full-duplex operation allows the
interface to send and receive signals at the
same time.
auto configures the interface to auto negotiate its
operational mode (either full-duplex or
half-duplex) with the device to which it is
physically connected.