Network Router User Manual

Release 1.0 System Administration Commands
526363-001-00 Rev. B MGBI 1-119
show logging reporting
The show logging reporting command displays the recording mechanism for logging
messages based on their severity level. The display output is in the format: logging
reporting <severity> <logging location> e.g. logging reporting alert local. The
following is an example of typical screen output from the show logging reporting
command:
The following information is displayed:
Severity Levels and Descriptions
emergency emergency conditions where the system is unusable -
reserved for vendor-specific, fatal hardware or software
errors that prevents normal system operation and causes
reporting system to reboot
(severity level = 0)
alert conditions where immediate action is needed - a serious
failure which causes the reporting system to reboot
but is
not caused by
hardware or software malfunctioning
(severity level = 1)
critical critical conditions - a serious failure that requires
immediate attention and prevents the device from
transmitting data but the system could recover without
rebooting
(severity level = 2)
no logging control docsis
logging reporting emergency local
logging reporting alert local
logging reporting critical local-trap-syslog
logging reporting error local-trap-syslog
logging reporting warning local-trap-syslog
logging reporting notice local-trap-syslog
logging reporting information all-clear
logging reporting debug all-clear