Computer Accessories User Manual

Installation On−Board Hardware Accessories
52 PENT/ATCA−717
3. Plug CompactFlash into socket
4. Close locking bow over CompactFlash disk
Note:aThe locking bow must enclose the disk completely.a
Removal Procedure
1. Open locking bow
2. Take CompactFlash disk′s ends and pull CompactFlash disk carefully out of
socket
3. Close locking bow again
CMC Debug Module
A CMC debug module is available as accessory kit for the blade. It is called
ACC/ATCA−CMC−MODULE and provides two serial and one keyboard/mouse
interface at its face plate. The CMC debug module is installed into PMC slot 4. For further
details refer to theaACC/ATCA−CMC−MODULE Installation Guide.aa