Technical information

Serial Interfaces

26 G30 - Module Hardware Description December 15, 2009

It is recommended to implement the above in accordance with the following table:

Note: Recommended application connector: SAMTEC TSM-106-02-S-DV-LC 12 pin.

C Bus Interface

The module provides an I

C bus interface which includes a serial data line and a clock line on the

board to board pins. The G30 I

C acts as master only. The I

C bus interface is available to the

user only with M2M Zone Platform.

The I

C signals are pulled-up, using internal 4.7 kOhm resistors.

Note: Do not connect any pull-up resistors when using signals as I

C interface.

Note: The I

C Bus interface can only be activated by M2M Zone Platform. Otherwise, the I

signals are configured as GPIOs.

Table 2-6: Data Logging and SW Upgrading Application

Connector

Pin #

(81 pin LGA

interface)

Pin #

(70 pin

connector

interface)

G30

Signal Name

Application Header

Connector Pinout

68-77 1-4 GND 1

78-79 5-8 VCC 9

762SPI_IRQ 10

27 25 RESET_IN 3

45 66 SPI_CLK 2

60 68 SPI_MOSI 8

61 64 SPI_MISO 6

63 70 SPI_CS 4

43 21 TXD 5

44 11 RXD 7

SPI connection

indication

Flashing connec-

tion indication