Technical information

Chapter 2: Introduction to AT Commands
August 5, 2008 AT Commands Reference Manual 2-15
+MRST This command enables customer software to perform a hard reset
to the G24 unit.
Page 3-213
+MTCTS This command sets the CTS pin of the RS232 to not active (high),
waits one second and then sets the CTS to active (low).
Page 3-204
+MTDTR This command checks and displays the physical current status of
the DTR pin of the RS232.
Page 3-203
+MTTY This command is used to enable/disable the TTY (Tele Typewriter)
support in the G24.
Page 3-44
+MVC
This AT command is used to choose and configure the
priority order of the supported voice codecs (vocoders).
Page 3-43
+TADIAG This command queries actual ADC values of the antennas.
Page 3-216
+TASW This command controls the antenna switch mechanism.
Page 3-215
+TCLCC This command displays a list of all current G24 calls and their
statuses, and also enables/disables the unsolicited indication of the
call list.
Page 3-51
+TPIN This command queries the number of remaining SIM PIN/PUK
entering attempts
Page 3-263
+TSMSRET This command controls the SMS sending retry.
Page 3-143
+TWUR This command is used to query the wakeup reason(s).
Page 3-215
+TWUS This command is used to set the wakeup reason(s).
Page 3-213
A This command answers an incoming call, placing the G24 into the
appropriate mode, as indicated by the RING message.
Page 3-19
D This command places a voice call on the current network, when
issued from an accessory device.
Page 3-13
E This command defines whether the G24 echoes the characters
received from the user, (whether input characters are echoed to
output).
Page 3-283
F This command is supported for backward compatibility only, and
has no effect.
Page 3-451
H This command hangs up, or terminates a particular call.
Page 3-17
I This command requests various G24 information items.
Page 3-6
L This command is supported for backward compatibility only, and
has no effect.
Page 3-451
M This command is supported for backward compatibility only, and
has no effect.
Page 3-451
N This command is supported for backward compatibility only, and
has no effect.
Page 3-451
O This command returns a phone to the Online Data mode and issues
a CONNECT or CONNECT <text> result code.
Page 3-34
Table 2-1: Core AT Commands (Cont.)
AT Command Description Page