Technical information

Core AT Commands
2-14 AT Commands Reference Manual August 5, 2008
+MFOTAABOR
T
Aborts the DM session.
Page 3-277
+MFOTABS Init OTA bootstrap definition.
Page 3-279
+MFOTACNFG This command enables setting the DM session as
Automatic/Non-Automatic (i.e. Transparent/Non-Transparent).
Page 3-273
+MFOTAIND This command sends Unsolicited FOTA indications toward DTE.
Page 3-277
+MFOTAINSTL Installs the updated package.
Page 3-276
+MFOTAREQ This command sends FOTA requests toward DTE.
Page 3-274
+MFOTARSP This command is used to send response to +MFOTAREQ reports.
Page 3-275
+MFOTAWSCF
G
This command sets the Web-Session default entry.
Page 3-271
+MGAUTH
This command enables Authentication Protocol setting
(CHAP/PAP).
Page 3-193
+MGEER This command returns the PDP context activation reject cause.
Page 3-307
+MGGIND This command configures the service indicator on pin 49 of the 70
pin connector to be GPRS or GSM.
Page 3-209
+MIOC
This command defines the G24 8 GPIO pins data value. Page 3-219
+MIOD
This command defines the G24 8 GPIO pins configuration. Page 3-223
+MIPCFF This command allows configuring the incoming TCP connection
filtering feature parameters, such as list of allowed IP addresses or
disabling/enabling the filtering.
Page 3-426
+MIPCONF This command allows to configure TCP stack parameters, such as
retransmissions number, upper and bottom limits of retransmission
timeout, close delay.
Page 3-412
+MIPCSC This AT command is used to configure the SSL feature behavior in
case of non - fatal alerts.
Page 3-423
+MIPDATA
This unsolicited event is sent to the terminal indicating a
data comes from Network when G24 is in pseudo-command
mode.
Page 3-410
+MIPODM This command causes the G24 module to initialize a new socket in
Online Data Mode and open a connection with a remote side.
Page 3-398
+MJDC This command enables/disables the Jamming Detection feature.
Page 3-196
+MMAD This command reads and monitors digital value from a specified
ADC.
Page 3-225
+MPSU This command defines the functionality of the second physical
UART.
Page 3-217
+MRICS This command allows configuring the behavior of RI line in a case
of SMS arrival.
Page 3-143
Table 2-1: Core AT Commands (Cont.)
AT Command Description Page