Technical information

Chapter 2: Introduction to AT Commands
August 5, 2008 AT Commands Reference Manual 2-13
+MADIGITAL This command switches between analog and digital audio modes.
Page 3-250
+MAFEAT This command controls the various algorithm features, such as
sidetone, echo cancel and noise suppress.
Page 3-249
+MAMUT This command controls the muting/unmuting of all input paths
(MIC, HDST_MIC, DIGITAL_RX).
Page 3-248
+MAPATH This command sets/requests the active input accessory, and the
output accessory for each feature.
Page 3-243
+MAVOL This command enables you to determine a volume setting for a
particular feature in a particular accessory.
Page 3-246
+MCEG This command disables / enables EDGE support in G24 modules
with EDGE support capability.
Page 3-364
+MCELL This command displays information about the Cellular Network.
Page 3-182
+MCST This command displays the current state of the call processing, and
also enables/disables the unsolicited indication of any change in the
call processing state.
Page 3-49
+MCWAKE This command displays reports on the status of the GPRS/GSM
coverage.
Page 3-208
+MDLC This command establishes PPP link over serial port.
Page 3-345
+MIAU This command manages IP Director addresses and port.
Page 3-346
+MSCTS This command defines the behavior of the CTS line when the G24
is in Sleep mode.
Page 3-296
+MDC This command enables you to select the desired messages to be
displayed upon connection of a voice call with a remote party.
Page 3-38
+MDSI This command enables unsolicited reporting of indications of SIM
deactivation and invalidation.
Page 3-78
+MEDT This command enables/disables the G24 tones.
Page 3-139
+MEMAS This command is used for Email account settings.
Page 3-151
+MEMD This command is used to delete an Email message.
Page 3-164
+MEMDE This command is used to download an Email message.
Page 3-155
+MEMISP This command is used for Email account ISP settings.
Page 3-150
+MEMGS This command is used for Email account general settings.
Page 3-153
+MEML This command is used to list Email messages.
Page 3-160
+MEMSE This command is used to send an Email message.
Page 3-157
+MEMR This command is used to read an Email message.
Page 3-163
+MEMW This command is used to write or update an Email message.
Page 3-166
+MFIC
This command instructs the G24 to query or set Filtering
Incoming Calls parameters.
Page 3-40
Table 2-1: Core AT Commands (Cont.)
AT Command Description Page