Technical information

Core AT Commands
2-10 AT Commands Reference Manual August 5, 2008
&Y This command displays the default user profile.
Page 3-318
? This command displays the most recently updated value stored in
the S-register.
Page 3-289
\A This command is supported for backward compatibility only, and
has no effect.
Page 3-451
\B This command is supported for backward compatibility only, and
has no effect.
Page 3-451
\G This command sets the use of the software flow control.
Page 3-288
\J This command adjusts the terminal auto rate.
Page 3-288
\K This command is supported for backward compatibility only, and
has no effect.
Page 3-451
\N This command displays the link type.
Page 3-288
\S This command displays the status of selected commands and
S-registers.
Page 3-288
+CBAUD This command sets the baud rate.
Page 3-200
+CEER This command returns an extended error report containing one or
more lines of information text, determined by the manufacturer,
providing the reasons for the call- clearing errors.
Page 3-304
+CFSN This command displays the factory serial number.
Page 3-6
+CFUN This command shuts down the phone functionality of smart phones
and PDAs with phone capabilities.
Page 3-210
+CGEQMIN This command allows the TE to specify a minimum acceptable
profile, which is checked by the MT against the negotiated profile
returned in the Activate/Modify PDP Context Accept message.
Page 3-354
+CGEQNEG This command allows the TE to retrieve the negotiated QoS
profiles returned in the Activate PDP Context Accept message.
Page 3-360
+CGEQREQ This command allows the TE to specify a EDGE Quality of Service
Profile that is used when the MT sends an Activate PDP Context
Request message to the network.
Page 3-348
+CGMI This command displays manufacturer identification.
Page 3-1
+CGMM This command requests the model identification.
Page 3-2
+CGMR This command requests the revision identification.
Page 3-3
+CGSN This command requests the product serial number identification.
Page 3-3
+CHUP This command causes the G24 to hang up the current GSM call.
page 3-35
+CIND This command is used to query the status of various ME indicators.
Page 3-324
+CKPD This command emulates key presses, or virtual keycodes, as if
entered from the G24 keypad or from a remote handset.
Page 3-318
+CLAC This command displays a list of all the AT commands supported by
the G24.
Page 3-9
Table 2-1: Core AT Commands (Cont.)
AT Command Description Page