Technical information

AT Commands Summary
1-34 AT Commands Reference Manual August 5, 2008
+MHDPB This command is used to enable and disable the SEND/END
functionality of the headset dual-position button.
Page 3-326
Unsolicited UI Status Messages
+CKEV This command causes the G24 to send an unsolicited message when
a key is pressed on the G24 keypad, and local key press echo is
enabled.
Page 3-328
+MUPB This command causes the G24 to send an event when a phone book
entry is accessed or modified by the user.
Page 3-330
+CDEV An unsolicited indication regarding display changes that is sent to
the DTE when the <disp> parameter of the +CMER command is set
to 1.
Page 3-329
+CIEV An unsolicited indication regarding various phone indications that is
sent to the DTE when the <ind> parameter of the +CMER command
is set to 1.
Page 3-329
GPRS
GPRS Commands
+CGCLASS This command sets the GPRS mobile station class.
Page 3-332
+CGDCONT This command specifies the PDP (Packet Data Protocol) context.
Page 3-333
+CGQMIN This command sets the minimum acceptable quality of service
profile.
Page 3-335
+CGQREQ This command displays the requested quality of service profile.
Page 3-337
+CGACT This command activates/deactivates the PDP Context.
Page 3-338
+CGPADDR This command reads the allocated PDP addresses for the specified
context identifiers.
Page 3-344
+CGATT This command attaches the G24 to the GPRS network.
Page 3-338
D*99 This command enables the ME to perform the actions necessary for
establishing communication between the terminal and the external
PDN.
Page 3-340
+CGPRS This command indicates whether there is GPRS coverage.
Page 3-342
+MDLC This command establishes PPP link over serial port.
Page 3-345
+MIAU This command manages IP Director addresses and port.
Page 3-346
EDGE Commands
+CGEQREQ This command allows the TE to specify a EDGE Quality of Service
Profile that is used when the MT sends an Activate PDP Context
Request message to the network.
Page 3-348
Table 1-1: AT Commands (Cont.)
AT Command Description Page