Technical information

Appendix A: Reference Tables
August 5, 2008 AT Commands Reference Manual A-19
+MNTFY
This command enables/disables
unsolicited report of NOTIFY
indication arrived from the NW.
Page 3-53
+MPCMC
This command defines whether
the PCM clock is generated
continuously or not, when
module is in digital audio mode.
Page 3-232
+MPDPM
This command returns the
collective percentage of memory
used by the phonebook and
datebook in their shared dynamic
memory storage.
Page 3-85
+MPING
This command will allow
verifying IP connectivity to
another remote machine
(computer) by sending one or
more Internet Control Message
Protocol (ICMP) Echo Request
messages.
Page 3-414
+MPINGSTAT
This is the unsolicited response
that the G24 sends to the terminal
to inform of ping execution status
update and provides summary
statistics of ping request when
ping request execution is
completed.
Page 3-418
+MPSU
This command defines the
functionality of the second
physical UART.
Page 3-217
+MRICS
This command allows
configuring the behavior of RI
line in a case of SMS arrival.
Page 3-143
+MRST
This command enables customer
software to perform a hard reset
to the G24 unit.
Page 3-213
+MSCTS
This command defines the
behavior of the CTS line when
the G24 is in Sleep mode.
Page 3-296
+MSDNS
This command set/read DNS IP
address for each socket.
Page 3-421
+MTCTS
This command sets the CTS pin
of the RS232 to not active (high),
waits one second and then returns
the CTS to active (low).
Page 3-204
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page