Technical information

AT Commands Alphabetical Summary
A-18 AT Commands Reference Manual August 5, 2008
+MIPSEND
This command causes the G24 to
transmit the data that the terminal
provides, using an existing
protocol stack.
Page 3-404
+MIPSETS
This command causes the G24 to
set a watermark in the
accumulating buffer. When the
watermark is reached, data is
pushed from the accumulating
buffer into the protocol stack.
Page 3-403
+MIPSSL
This unsolicited event is sent to
the terminal indicating an errors,
warnings or alerts that occurred
during SSL connection.
Page 3-428
+MIPSTAT
This unsolicited event is sent to
the terminal indicating a change
in link status.
Page 3-409
+MIPXOFF
This unsolicited event is sent to
the terminal to stop sending data.
Page 3-410
+MIPXON
This unsolicited event is sent to
the terminal when the G24 has
free memory in the accumulating
buffer.
Page 3-411
+MJDC
This command enables/disables
the Jamming Detection feature.
Page 3-196
+MKPD This command enables
accessories to control the press
and release of key presses.
Page 3-320
+MMAD This command reads and
monitors digital value from a
specified ADC.
Page 3-225
+MMAR
This command changes the status
of an SMS message in the G24
memory from "REC UNREAD"
to "REC READ".
Page 3-125
+MMICG
This command handles the
selection of microphone gain
values.
Page 3-252
+MMGL
This command displays a list of
SMS messages stored in the G24
memory.
Page 3-114
+MMGR
This command enables the user
to read selected SMS messages
from the G24 memory.
Page 3-118
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page