Technical information

Appendix A: Reference Tables
August 5, 2008 AT Commands Reference Manual A-17
+MIPCLOSE
This command causes the G24
module to free the socket
accumulating buffer and
disconnect the G24 from a
remote side.
Page 3-401
+MIPCONF
This command allows to
configure TCP stack parameters,
such as retransmissions number,
upper and bottom limits of
retransmission timeout, close
delay.
Page 3-412
+MIPCSC
This AT command is used to
configure the SSL feature
behavior in case of non - fatal
alerts.
Page 3-423
+MIPDATA
This unsolicited event is sent
to the terminal indicating a
data comes from Network
when G24 is in
pseudo-command mode.
Page 3-410
+MIPFLUSH
This command causes the G24
module to flush (delete) data
accumulated in its accumulating
buffers.
Page 3-407
+MIPODM
This command causes the G24
module to initialize a new socket
in Online Data Mode and open a
connection with a remote side.
Page 3-398
+MIPOPEN
This command causes the G24
module to initialize a new socket
and open a connection with a
remote side.
Page 3-396
+MIPPUSH
This command causes the G24
module to push the data
accumulated in its accumulating
buffers into the protocol stack.
Page 3-406
+MIPRTCP
This unsolicited event is sent to
the terminal when data is
received from the TCP protocol
stack.
Page 3-408
+MIPRUDP
This unsolicited event is sent to
the terminal when data is
received from the UDP protocol
stack.
Page 3-408
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page