Technical information

AT Commands Alphabetical Summary
A-16 AT Commands Reference Manual August 5, 2008
+MFOTARSP
This command is used to send
response to +MFOTAREQ
reports.
Page 3-275
+MFOTAWSCFG
This command sets the
Web-Session default entry.
Page 3-271
+MFS
This command is used to
determine how long the G24
waits before attempting to
re-register after a registration
attempt has failed and the G24 is
not registered.
Page 3-180
+MGAUTH
This command enables
Authentication Protocol
setting (CHAP/PAP).
Page 3-193
+MGEER
This command returns the PDP
context activation rejece cause.
Page 3-307
+MGGIND
This command configures the
service indicator on pin 49 of the
70 pin connector to be GPRS or
GSM.
Page 3-209
+MHDPB
This command is used to enable
and disable the SEND/END
functionality of the headset
dual-position button.
Page 3-326
+MHUP
This command Hung UP call(s)
and report specific cause to the
NW.
Page 3-42
+MIAU
This command manages IP
Director addresses and port.
Page 3-346
+MIOC
This command defines the
G24 8 GPIO pins data value.
Page 3-219
+MIOD
This command defines the
G24 8 GPIO pins
configuration.
Page 3-223
+MIPCALL
This command creates a wireless
PPP connection with the GGSN
or CSD service provider and
returns a valid dynamic IP for the
G24.
Page 3-394
+MIPCFF
This command allows
configuring the incoming TCP
connection filtering feature
parameters, such as list of
allowed IP addresses or
disabling/enabling the filtering.
Page 3-426
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page