Technical information

Chapter 3: AT Commands Reference
August 5, 2008 AT Commands Reference Manual 3-413
MIPCONF - Configure Internal TCP/IP stack
This command allows to configure TCP stack parameters, such as retransmissions number, upper
and bottom limits of retransmission timeout, close delay. It can be used to configure TCP socket
parameters before socket activation or when the socket is in active state. Configuration values
will be stored in G24 until power circle.
Command Type Syntax Response/Action Remarks
Set
AT+MIPCONF=<
socket>[,[<retr_n
um>],[<min_TO>
],[<max_TO>],[<
max_close_delay>
][,<is_nack_ind_r
eq>][,<keep_alive
_timeout>][,<keep
_alive_interval>][,
<keep_alive_prob
es>]]
OK
or:
+CME ERROR: <err>
The Set updates TCP
stack configuration
parameters.
Read
+MIPCONF? +MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,<
max_close_delay>,<is_nack_ind_req>,<
keep_alive_timeout >,<
keep_alive_interval >,<
keep_alive_probes ><CR><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,<
max_close_delay>,<is_nack_ind_req>,<
keep_alive_timeout >,<
keep_alive_interval >,<
keep_alive_probes ><CR><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,<
max_close_delay>,<is_nack_ind_req>,<
keep_alive_timeout >,<
keep_alive_interval >,<
keep_alive_probes ><CR><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,<
max_close_delay>,<is_nack_ind_req>,<
keep_alive_timeout >,<
keep_alive_interval >,<
keep_alive_probes >
he read command
returns current
settings of TCP stack
parameters.
Test
+MIPCONF=? +++MIPCONF:
(1-4),(1-5),(1-10),(10-600),(1-75),(0-2),(0-
18000) ,(1-18000),(1-10)
The Test command
returns the possible
parameters values.
Time values can be
inserted with
resolution of 100
milliseconds. Keep
alive time value
resolution is in
seconds.