User`s guide

LED INDICATIONS GENERAL FEATURES Status (Trunking Systems Only) Selecting Transmit Power Level
Sending an Emergency Alarm Sending a Silent Emergency Alarm Cancelling an Emergency Alarm Sending an Emergency Call
Failsoft Operation (Trunked Systems Only) Muting Keypad Tones Scanning
Turning Scan On or Off Deleting Nuisance Modes
Action
LED
Condition
Meaning
Press the PTT button to transmit
Steady red Normal transmission Unlit Not transmitting
Release the PTT button to receive
Single red flash
Mode busy (clear) (conventional modes only)
Two red flashes
Mode busy (encrypted) (conventional modes only)
Flashing green
Receipt of phone call, private conversation call, dispatcher interrupt call, conventional selective call, or Call Alert page
1 Press < or > until the display shows the STS
softkey.
2 Press m below STS.
The display shows the last acknowledged status.
3 Press < or > until the display shows the desired
status, or enter the list item’s number using the keypad.
4 Press the PTT button to transmit the selected status.
5 Press O to exit status and return to the home display.
1 Press < or > until the display shows the PWR
softkey.
2 Press m below PWR.
The display shows HIGH POWER or LOW POWER.
3 Press m below the LOW or HIGH softkey.
The radio returns to the home display.
Press and hold the orange top button (T2). The red LED lights steadily. You hear an emergency tone. The display alternately shows EMERGENCY and the current zone and mode names. When the alarm is acknowledged by the dispatcher, you hear four beeps. The radio returns to normal operation.
Press and hold the orange top button (T2). The radio transmits the emergency without any external indication than an alarm is in progress.
Press and hold the emergency button before the alarm is acknowledged. You hear an exit tone and the radio returns to normal operation. If the radio does not return to normal operation, press the PTT button. The radio does NOT sound an exit tone.
1 Press and hold the orange top button (T2).
The red LED lights steadily. You hear a short, medium-pitched emergency tone. The display alternately shows EMERGENCY and the current zone and mode names.
2 Press the PTT button and announce your emergency. 3 To exit emergency call mode, press the emergency
button for a little over 1-1/2 seconds (or for the duration specified by your system manager). You hear a medium-pitched exit tone and the radio returns to normal operation
During Failsoft operation, you hear a faint beeping tone every ten seconds. The radio unsquelches. The display alternately shows FAILSOFT and the current trunked mode name.
1 Press < or > until the display shows the MUTE
softkey.
2 Press m below MUTE.
The display shows TONES ON or TONES OFF and the
ON and OFF softkeys.
3 Press m below ON or OFF.
The radio saves your selection and returns to the home display.
1Press < or > until the display shows the SCAN
softkey.
2Press m below SCAN.
The display shows SCAN ON or SCAN OFF and the ON and OFF softkeys.
3Press m below ON or OFF. The display shows G.
When you select OFF, the radio stops scanning and returns to the home display.
1 When the radio is locked onto the mode you want to
delete, press < or > until the display shows the NUIS softkey, Alternatively, press the preprogrammed Nuisance Delete button. The mode is deleted and you hear a valid key-press chirp.
2 To resume scanning the deleted mode, turn scan off
and then back on again.