User`s guide
84
4. Program the target radio by pressing
F8
from the PROGRAM
RADIO screen (
F3/F8) or from the CLONE RADIO screen (F3/F5).
5. Save the target codeplug image to an archive file.
Note: A radio and RIB must be properly connected to the computer
and power turned on before you attempt the PROGRAM function.
Note: The time required to clone a codeplug will depend directly
on your computer type and the size of the codeplug being
cloned.
Function Key Descriptions
F2 - READ SER NUMBER
(Read serial number)
Allows you to read the serial number/codeplug data of the “target”
radio.
F3 - CONV ID
(Conventional ID)
Brings up the MDC DATA CLONING screen where you assign MDC
IDs. This function will be active only when a Conventional radio is being
cloned.
F4 - LIMITED CLONE This function is used to clone the Conventional and Radio wide
sections of the codeplug. It deletes the Trunking data and reads the serial
number from the radio. Trunking System Keys (or FTR Key) are required
for cloning Trunking system data. Limited Clone requires the target
radio to be connected so that the serial number can be read.
F6 - DUPLICATE II/IIi ID Duplicates the selected Type II/IIi ID (the one under the cursor) into
all other Trunking Type II/IIi personalities for which System Keys are
present.
F7 - SAVE FILE Creates or updates an archive copy of the codeplug information onto
a diskette or hard disk.
Note: An archive copy of every radio installed or serviced is
strongly recommended to be able to quickly restore customer
information in case of a codeplug failure.
F8 - PROGRAM RADIO Transfers codeplug information from the computer to the radio
codeplug.