User`s guide

56
8. For ASTRO SABER radios, press the UP/DOWN arrow keys to select
Scan for position A and Blank for position B. For XTS 3000 radios,
press Tab to advance to the Three-Position Toggle Switch and then
press the UP/DOWN arrow keys to select Scan for position A and
Blank for positions B and C.
9. Press Tab to advance to the Rocker Switch field (for ASTRO SABER
radios) or to the Two-Position Concentric Switch (for XTS 3000
radios).
10. Use the UP/DOWN arrow keys to select Secure Tx for position B
(XTS 3000 radios) or Position 2 (SABER radios) as appropriate.
NOTE: You must have a Secure-equipped radio to perform this step.
11. Press Esc to return to the MAIN MENU.
Program Personality
into the Radio Codeplug
Now that you have set values for all the features you want, it is time to
actually program them into the radio. Programming the personality into
the radio’s codeplug must be done after creating or editing the personality of
a radio or else the changes will be lost.
1. Press F3 at the MAIN MENU to bring up the GET/SAVE MENU.
2. Press F8 at the GET/SAVE MENU to bring up the PROGRAM
RADIO screen. The current data stored in the computer's RAM
(what you can see on the RSS screens) is programmed into the
radio's codeplug. Make sure that the radio is connected to the RIB and
that both the RIB and the radio are powered up before pressing F8.
!
Caution
When programming or tuning a radio DO NOT
disconnect the radio from the RIB when the computer
is communicating with the radio. This action may leave
the radio in an inoperable state. Disconnect the radio
only when you are in the MAIN MENU or GET/SAVE
screens.