User`s guide

53
Program Trunking
Personalities
After the Trunked system has been added, a Trunking personality must
be created to support that system. Follow the steps below to program
a Trunking personality with two talkgroups.
NOTE: You must have a System Key to create a Trunking
personality.
1. From the TRUNKING MENU, press F4 to go to the TRUNKING
PERSONALITY screen.
2. Press F2 to add a personality. Press F2 again to insert after the
current entry or F3 to add to the end of the list.
3. Press Tab to advance the prompt to System ID field.
4. Use the UP/DOWN arrow keys to select the desired System ID.
5. Press F7 to access the TRUNKING TALKGROUPS screen.
6. At the Tlk Grp field enter the desired Talkgroup ID.
7. Press Tab to advance the prompt to the Tx Voice/Signal Type Field.
8. Use the UP/DOWN arrow keys to make your selection.
9. Press F2 to add a Talkgroup.
Repeat steps 6 through 8 for each additional Talkgroup.
10. Press F10 three times to exit to the CHANGE/VIEW MENU.
Program Zone/Channel
Features
Now that the Trunking personalities are programmed, follow the steps
below to assign these personalities to rotary channel positions in the
ZONE/CHANNEL ASSIGNMENT screen.
1. Press F4 from the MAIN MENU to access the CHANGE/VIEW
MENU. Press F8 to bring up the ZONE/TALKGROUP (CHANNEL)
ASSIGNMENT screen.
2. If the Trunking Personalities are to be added to a new zone, press
F2 to add a Zone. Press F2 again to insert after the current entry or
F3 to add to the end of the list.
3. Press Tab to advance to the Zone Name field.
4. Type in the desired Zone name.
5. Press F6 as many times as necessary to add the desired number of
channels.
6. Press Tab to advance to the Channel Name field.
7. Type in the desired Channel Name.
8. Press Tab to advance the prompt to the Personality Type field.
9. Use the UP/DOWN arrow keys to select “Trunk”.
10.Press Enter or Tab to advance to Personality Number field and
enter the desired personality number.
11.Repeat steps 6 and 10 for additional Channel numbers.
12.Press F4 to go to the next zone.
Repeat steps 4 through 9 for each Zone.
13. Press F10 to exit to the CHANGE/VIEW MENU.