User`s guide

9. Repeat steps 6 through 8 for the other channels.

10. Press F10 to return to the CHANGE/VIEW MENU.

NOTE: If more than 16 personalities (channels) were created,

an additional zone will be required. Zones can be added on the

ZONE/CHANNEL ASSIGNMENT screen (F4/F8) by pressing F2.

Fill In the Scan List Now that the Zone/Channel features have been programmed, ﬁll in

the Scan List as follows:

1. From the CHANGE/VIEW MENU, press F3 to access the RADIO

WIDE CONFIGURATION MENU.

2. Press F5 to bring up the SCAN LIST screen. If “1” is not already

displayed under Scan List number, press F3 to see the previous list.

If “1” is displayed, proceed to the next step.

3. Press Tab to advance the prompt to the Member Zone (Zn) ﬁeld.

4. Type the number of the zone to be scanned. (Type “1” for purposes

of this tutorial.) Press Enter.

5. Type the desired channel number and press Enter to select this

number.

Repeat steps 3 through 5 until all the desired channels are entered.

6. If you have created a Scan List with more than 8 members, press

Pg Up/Pg Dn to access all members of the Scan List. We will

assume that factory defaults are suitable for the remaining ﬁelds.

7. Press Esc to return to the MAIN MENU.

Program Personality

into the Codeplug

Now that you have set values for all the features you want, it is time to

actually program them into the radio.

NOTE: Programming the personality into the radio’s codeplug

must be done after creating or editing the personality of a

radio or else the changes will be lost.

1. Press F3 at the MAIN MENU to bring up the GET/SAVE MENU.

2. Press F8 at the GET/SAVE MENU to bring up the PROGRAM

CODEPLUG screen. The current data stored in the computer's

RAM (what you can see on the RSS screens) will be programmed

into the radio's codeplug.

NOTE: Make sure that the radio is connected to the RIB and that

both the RIB and the radio are powered up before pressing F8.

Caution

When programming or tuning a radio DO NOT

disconnect the radio from the RIB when the computer

is communicating with the radio. This action may leave

the radio in an inoperable state. Disconnect the radio

only when you are in the MAIN MENU or GET/SAVE

screens.