User`s guide

42
Program the Phone List
(
if applicable )
Listed below are the steps required to create a phone list for an ASTRO
radio ( This task can be programmed ONLY if the Phone List feature is
available on the current model ):
1. Press F4 at the RADIO WIDE CONFIGURATION MENU to bring up
the PHONE CONFIGURATION screen.
2. Press Tab as many times as necessary to advance the prompt to the
Phone Num Display Format field.
3. Use the UP/DOWN arrow keys to select USA.
4. Press Tab to advance the prompt to the Phone Number field.
5. Type in the desired phone number.
6. Press Tab to advance the prompt to the Phone Text field.
7. Type in the desired name.
8. Repeat steps 4 through 7 to add additional phone numbers and
names. Press the Pg Dn/Pg Up keys to access the next/previous
screen of phone numbers.
9. Press F10 twice to return to the CHANGE/VIEW MENU.
Program Conventional
Personalities
Follow the steps listed below to program Conventional personalities:
1. From the CHANGE/VIEW MENU, press F6 to bring up the
CONVENTIONAL MENU.
2. Press F3 to access the CONVENTIONAL PERSONALITY screen. The
personality number will be highlighted. Add new personalities by
pressing F2 , and then F2 again to insert after the current
personality or F3 to add to the end of the list. Repeat this until the
desired number of personalities are added. Press F4 to return to
Personality 1.
3. Press Tab to advance to the Scan List field. Use the UP/DOWN
arrow keys to select the appropriate scan list, “1” or “2”.
4. Press Tab to advance the prompt to the Phone Operation field. Use
the UP/DOWN arrow keys to scroll through the available choices
(None, Unlimited or List Only) and make your selection.
5. Press Tab to advance the prompt to the Rx Voice/Signal Type field.
Select the appropriate signalling type (ASTRO, Non ASTRO, or
Mixed Mode) using the UP/DOWN arrow keys.
6. Press Tab to advance the prompt to the Receive Frequency field.
Type in frequency data or make a selection using the UP/DOWN
arrow keys. If the Rx Voice/Signal Type is ASTRO, skip to step 9.
7. Press Tab advance the prompt to the Receive Squelch Type field.
Use the UP/DOWN arrow keys to select PL, DPL or CSQ.
8. If your selection for Squelch Type is PL or DPL, press Tab to
advance the prompt to the Code field. Use the UP/DOWN arrow
keys to scroll for choices, or type in the code directly.
9. Press Tab to advance the prompt to the Transmit Frequency field.
Type in frequency data, or use the UP/DOWN arrow keys to scroll
through the available choices and make the desired selection. If
the Rx Voice/Signal Type is ASTRO, skip to step 14.