User`s guide

272
Radio Inhibit Use the UP/DOWN arrow keys to enable/disable this feature. The
Radio Inhibit feature allows the radio to respond to a remote Inhibit
signal which is essentially a shut-down command from the dispatcher.
Upon receipt of this command, the radio transmits a quick
acknowledgment to the dispatch equipment. It then goes into a
dormant state during which the receiver audio is muted and the
transmit audio path is blocked. In addition, all operator controls are
rendered inoperative, channel scan is stopped on the operating Mode
which received the command, and all LEDs are turned off.
The radio will remain in this Inhibited state until it receives an Enable
command. Alternatively, the radio may be uninhibited by reading and
re-writing its codeplug with the RSS.
Status Use the UP/DOWN arrows to enable/disable this feature. The Status
feature, when enabled, allows the user to select and transmit a specific
status from a list pre-programmed into the radio. A complete
activation of the Status feature therefore includes first enabling the
feature and then programming the desired status list to be made
available to the user. Status list programming is performed from the
STATUS ALIAS screen (F4/F6/F9). Enabling this field also allows for the
setting of the Status Request RSS option
If this field is set to Disabled, the user will not be able to select and
transmit a status from the radio's list to set the Status Request RSS
option.
Status Request This field will be visible only if the Status field on this screen is set to
Enabled. Use the UP/DOWN arrow keys to enable/disable this feature.
If Status Request is enabled, the radio responds to a remote status
interrogation with the last attempted status. Disabling the feature
prohibits the radio from responding to a remote status interrogation.
Message Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, the user can select and transmit a specific message
from a list pre-programmed into the radio. To activate the message
feature, you must first set this field to Enabled and then program the
message list from the MESSAGE ALIAS screen (F4/F6/F8). If this field
is set to Disabled, the radio user will not be able to select and transmit
a message from the radio's list.
Emergency Use the UP/DOWN arrow keys to enable/disable Emergency for the
current system. The type of Emergency can then be specified in the
Emergency Type field on this screen.