User`s guide

267
Conventional
Personality RAC
Options
From the MAIN MENU, press F4, F6, F3, F9 and then F7 to access this
screen.
This screen can be accessed from the CONVENTIONAL PERSONALITY
OPTIONS screen (F4/F6/F3/F9) only if the current radio is RAC-capable
and if either Rx Voice/Signal Type or Tx Voice/Signal Type is not set to
ASTRO.
This screen contains all the personality specific RAC-related
information. The information contained in this screen will change
depending on the current personality. Press Tab to select the desired field,
or press the desired function key (F1 - F10). If a field is highlighted, use
the UP/DOWN arrow keys to select the desired choice or value.
Field Definitions
Personality This is a view only field that displays the current personality.
Note: This field cannot be edited.
Repeater Access This option enables Repeater Access on this personality. Repeater
Access as the name indicates is used to access a Repeater. Typically,
upon receiving the Repeater Access code word the Repeater will
remain in repeat mode until the hangtime expires. Repeater Access can
be one of the following:
Tone Signalling System This field will be visible only if the Repeater Access field is set to Enabled.
Use the UP/DOWN arrow keys to select the Single Tone signalling
system to be used by this personality.
Access Strapping Use the UP/DOWN arrow keys to set Access Strapping to Mode Slaved
or Operator Selectable.
DFCIG
MOTOROLA Radio Service Software Use UP/DOWN Arrows to Select
ASTRO Model: Personality.
...CHANGE/VIEW:CONV:PERS:OPTIONS:RAC
Personality... 1
CONVENTIONAL PERSONALITY RAC OPTIONS
------------------------------------
Repeater Access..................Enabled
Tone Signalling System................1
Access Strapping.............Mode Slaved
Access Type.......................Manual
RAB 1 Code Type..............Singletone
RAB 1 Singletone (Hz)...........1-300.0
RAB 2 Code Type.....................None
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP EXIT
Manual The Repeater Access code word will be sent when the side
button designated for Repeater Access is pressed.
Automatic The Repeater Access code word will be sent preceding every
user-initiated transmission.