User`s guide

261
Note: Receive-only personalities must always revert.
Rx Network ID Use the UP/DOWN arrow keys to scroll through the available Rx
Network ID values, or enter the value directly. It may take a few seconds
for the screen to update to the new value. The Rx Network ID feature
allows the separation of addressing modes among co-channel and
adjacent channel users. This feature is similar to the Private-Line (PL)
and Digital Private-Line (DPL) features which exist in analog radios. By
choosing an Rx Network ID, the radio can selectively address (choose)
one of several Repeaters within overlapping coverage areas allowing
the user to listen to a specific Repeater. The valid range of values is 0-
FFF in increments of 1.
Note: If the Direct Frequency Enable field is set to Disabled, the Direct
Network ID will be slaved to the Rx Network ID.
Note: When Rx Unmute Rule is set to Digital CSQ, this field will be
set to 293.
Tx Network ID Use the UP/DOWN arrow keys to scroll through the available Tx
Network ID values, or enter the value directly. It may take a few seconds
for the screen to update to the new value. The Tx Network ID feature
allows the separation of addressing modes among co-channel and
adjacent channel users. This feature is similar to the Private-Line (PL)
and Digital Private-Line (DPL) features in analog radios.
By choosing a Tx Network ID, the radio can be made to selectively
address (choose) one of several Repeaters within overlapping coverage
areas allowing the user to key-up a specific Repeater. The valid range of
values is 0-FFF in increments of 1.
Note: When Rx Unmute Rule is set to Digital CSQ, this field will be
set to 293.
Direct Network ID Use the UP/DOWN arrow keys to scroll through the available Direct
Network ID values, or enter the value directly. The Direct Network ID
feature allows the separation of addressing modes among co-channel
and adjacent channel users. This feature is similar to the Private-Line
(PL) and Digital Private-Line (DPL) features which exist in analog
radios.
By choosing a Direct Network ID, the radio can be made to selectively
address (choose) one of several Repeaters within overlapping coverage
areas allowing the user to key-up a specific Repeater. The Direct
Network ID will be used whenever the radio is in direct (talkaround)
mode. Otherwise the Tx Network ID will be used.
If the Direct Frequency Enable field is set to Disabled, the Direct
Network ID will be slaved to the Rx Network ID. The valid range is 0-
FFF in increments of 1.
Note: When Rx Unmute Rule is set to Digital CSQ, this field will be
set to 293.
Late Entry Fast Unmute This field is displayed for radios equipped with CAI Digital Operation only.
When this field is enabled, a radio that begins receiving a call already