User`s guide

259
Disabled, the Auto Sel Call Transmit field on this screen will NOT be
visible.
Selective Call Encode Use the UP/DOWN arrow keys to enable/disable this option. When
this field is set to Enabled, the user can send calls to an individual or a
group of radios. This option is intended to eliminate the annoyance
users experience when they receive traffic that does not pertain to
them.
Note: If this feature is set to Enabled, and selection of target radio(s)
IDs via Call list is to be made available to the user, data must be
programmed into the appropriate Call List Table.
Auto Sel Call Transmit Use the UP/DOWN arrow keys to enable/disable the Auto Selective
Call Transmit option. If the Auto Sel Call Transmit option is enabled,
the radio will remain on Selective Call mode after the PTT switch is
released.
ASTRO Unlimited Calling To be able to take advantage of this feature, a radio must be equipped with
a numeric keypad. Use the UP/DOWN arrow keys to enable/disable
Unlimited Calling. With this option enabled, the user is able to
directly enter from the keypad the ID of radios to be called. Target
Radio ID selection via the programmed Call List instead is still
available for models so equipped.
Note: This option affects only the Call Alert Encode and Selective
Call Encode features. This field is visible if either Call Alert Encode or
Selective Call Encode is Enabled.
Adaptive Power Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, the radio will use a lower power level if the station
reports that it received a strong signal from the subscriber. The radio
will always transmit with full power initially. Once the radio dekeys, it
will look for a data message from the station. If the station reports that
the last reception was strong, the radio will switch to the 1/2 power
setting.
Note: Adaptive power is only available on ASTRO Tx channels.
Rd Lap This field is not visible for radios equipped with CAI Digital Operation. Use
the UP/DOWN arrow keys to enable/disable this feature. If this field is
set to Enabled, the radio will be able to transmit ASTRO data packets
(such as Status, Message, Emergency, etc.). If this field is set to
Disabled, the operation of these features is inhibited in the radio.