User`s guide

220
Call ID List This field will not be visible if the Operation field is set to Resp Only. Use
the UP/DOWN arrow keys to select the Call List ID for the current
personality. This is the number of the Call ID list that this personality
will use for Private Call and Call Alert. The Private Call and Call Alert
features must have a call list assigned for Unlimited and List operation. The
Call ID List cannot be set to None when Call Operation is List or Unlimited.
Note: Radio controls may require additional setup for your Private
Call configuration on the RADIO WIDE BUTTON/SWITCH
CONFIGURATION screen (F4/F3/F3). Refer also to the
TRUNKING WIDE CALL LIST (F4/F4/F6) help screen.
Scan List Use the UP/DOWN arrow keys to select the Scan List to be used for this
personality. To change or view the scan list, access the SCAN LIST
screen (F4/F3/F5). Trunking personalities may use Subfleet, Priority
Monitor and Talkgroup type scan lists.
Note: Radio controls may require additional setup for your Scan
configuration on the RADIO WIDE BUTTON/SWITCH
CONFIGURATION screen (F4/F3/F3).
F/W Failsoft This field will be visible only when the Protocol Type is IIi, and the Failsoft
Type is Subfleet.
F/W Failsoft Freq (MHz) This field will be visible only when the Protocol Type is IIi, and the Failsoft
Type is Subfleet.
A/G Failsoft This field will be visible only when the Protocol Type is II, and the Failsoft
Type is Talkgroup. Use the UP/DOWN arrow keys to enable/disable
Failsoft for this talkgroup. When the Central Site Controller fails in a
Trunked system, the system goes into Failsoft operation. If the radio is
set to Failsoft by Talkgroup, the radio will use these frequencies to
transmit and receive on.
A/G Failsoft Frequency (MHz) This field displays only when the Protocol Type is II, and the Failsoft Type is
Talkgroup. Enter the Failsoft Frequency directly in MHz.
F/S Frequency (MHz) Enter the frequency (in MHz) for Failsoft operation; if the repeater
system fails, the radio will go into Failsoft mode (if the Failsoft feature
has been enabled). This means the radio will act like a Conventional
talkaround radio, transmitting and receiving on the same frequency,
referred to as the Failsoft frequency.