User`s guide

216
System/ID Use the UP/DOWN arrow keys to select the Trunking system the
current personality is to use. (The system ID is shown according to
system number). The Trunking system should be set up on the TRUNKING
SYSTEM screen (F4/F4/F3) before personality information is entered since
some of these fields depend on Trunking system information.
Type Use the UP/DOWN arrows to make your selection. The selection in
this field indicates the Trunked signalling protocol used on this
system. If the Trunking System is Type II or IIi, the individual ID is a four-
digit hexadecimal number. For Type II Trunking, your radio will have
a single Individual ID for each system, independent of the number of
talkgroups, user groups or personalities it is affiliated with on that
system.
Announcement Group Enter a three-digit hexadecimal number for the Announcement
Talkgroup directly. This field contains the user talkgroup for
announcements for the current personality.
ASTRO AG Strapping This field will be visible only when the Announcement Group is not set to
None. Use the UP/DOWN arrow keys to make your selection. You can
select ASTRO Strapping for the Announcement Group (F4/F4/F4), and
also select ASTRO Strapping for the Talkgroup on the TRUNKING
TALKGROUPS screen (F4/F4/F4/F7). Valid choices are Analog and
Digital.
Fleet ID A system key or FTR key is required to access this field. The Fleet ID is a
three-digit hexadecimal number where the first digit is the prefix and
the second two digits refer to the fleet. For any size code, the subfleets
for Fleetwide and Dynamic Regrouping are always available. The
Announcement Group may or may not be included in the Talkgroup
list entered by F7. Also, Failsoft for the announcement may be disabled
on this screen.
The valid range for the Fleet I depends on the size code chosen. Examples of
Fleet IDs are 300, 402, 001, and 703.
Strapping Use the UP/DOWN arrows to select the Transmit mode of the
Announcement Group or Fleet ID for this personality from among the
following:
Size Code A system key or FTR key is required to access this field. Use the UP/DOWN
arrow keys to choose the Size Code for this fleet. The Size Code
determines the maximum number of fleets, subfleets and individual
IDs allowed. Valid size codes are: A, B, C, D, E, F, G, H, I, J, K, M, O and
Q. For any size code, the subfleets for Fleetwide and Dynamic
Regrouping are always available.
Note: The size code and fleet ID chosen must match the
programming of the Central Controller.
Clear or Secure The Announcement Group or Fleet ID is forced to that
particular transmit mode.
Select The user is allowed to select the Secure transmit modes
using the radio's two-position concentric switch.