User`s guide

187
Function Key Descriptions
F2 - SMRTZN ENV
(SmartZone Environment)
This function will be visible only when a radio with the SmartZone software
option has been read. Displays the screen where SmartZone operating
environment parameters are defined.
F3 - VOC OPT
(Voice-On-Control Options)
This function will be visible only when a radio with the Voice-On-Control
option has been read. Displays the screen which allows you to specify
options for Voice-On-Control sites.
Field Definitions
Telephone Interconnect This option allows the radio to initiate and receive land-to-mobile
telephone calls and specifies the type of interconnect.
Note: Portable products that can be programmed by this RSS support
half-duplex phone communication ONLY.
ISW Window Adjust Use the UP/DOWN arrow keys to choose a code or enter the code
directly. The ISW Window Adjust value is a timing parameter that is
used to fine-tune Trunking system performance. It controls the time
for the launch of the ISW. Decreasing this value causes the ISW to
launch earlier and increasing this value causes the ISW to launch later.
The valid range of values is 0 (zero) to FFFF in increments of 1.
Auto Dial Holdoff (ms) Use the UP/DOWN arrow keys to select the amount of time the radio
will wait after gaining access to the phone channel before a pre-
queued phone number will be dialed. It ensures that the fixed end is
ready for dialing to commence. Normally, the user waits for a dial
tone, but in this case, the radio is dialing and cannot detect dial tone.
Valid entries range from 0 (zero) to 6375 in the increments of 25 ms.
RF Modem This field will be visible for Mobiles only. Use the UP/DOWN arrow keys
to enable/disable the Radio Frequency Modem function of the radio.
If RF Modem is enabled, the radio will be able to function only as an
RF Modem (that is, for use with Trunking System Watch PC Software).
When RF Modem is disabled, the radio will operate normally.
Note: This feature must be Enabled for the radio to operate with
System Watch.
Half duplex Implies that communication can take place in one
direction at a time only.
Full duplex Permits communication in both directions
simultaneously.
!
Caution
Do NOT modify this field unless you are a Motorola
Field Technical Representative or unless you understand
Trunking system timing and are absolutely certain that
your modification is correct. Changing the ISW Window
Adjust may actually degrade Trunking system
performance.