User`s guide

162
HUB Suspends Scan Use the UP/DOWN arrow keys to enable/disable HUB Suspends Scan
which determines whether or not scan operation will be suspended
while the microphone is removed from the hang-up box. This will
allow the user to complete a conversation while scan is suspended. For
Portables, this option is applicable only when a Vehicular Adapter is used.
Carrier Detect Required Use the UP/DOWN arrow keys to enable/disable this feature. When
this option is enabled, the radio will stop scanning and operate on the
priority channels based on carrier squelch detect. But it will unmute
only on the standard signalling conditions programmed for that
channel.
Priority Chan Marking Use the UP/DOWN arrow keys to enable/disable this feature. When
this option is enabled and the radio is in Priority Scan mode, the radio
checks the channel for activity and proper PL. If the channel has
Carrier but the wrong PL or no PL, the channel is marked so that the
radio will not check a second time for the proper PL. The radio will not
unmute on this channel until carrier is dropped. This is done to
eliminate time spent checking for proper PL and thus minimize audio
holes.
Note: Care should be exercised in using this feature. There is the
possibility that messages could be missed especially if long repeater
hangtimes are used.
Time Between Pri Samples (ms) This field represents the time interval that the radio waits between
taking samples of the priority channel in the scan list. This value is
only applicable during conventional priority scanning. The range is
from 250ms to 6375 ms in increments of 25 ms. The factory default is
500 ms for Portables and 550 ms for mobiles.
Monitor Hold Time (sec) Use the UP/DOWN arrow keys to select the Monitor Hold Time. Scan
Monitor Hold time is the time the radio remains on a designated
transmit conventional channel during scan after the monitor button
has been released. Valid entries range from 0 (zero) to 255 seconds in
one-second increments.
Failsoft Hold Time (sec) Use the UP/DOWN arrow keys to select Trunking Failsoft Activity
Time. This value determines how long the radio will stay unmuted on
a failsoft channel if failsoft is found while in talkgroup scan. Valid
values range from 1 to 255 seconds in one-second increments. You
may also select Disabled.
System Search Time (sec) This timer applies only to systems which do not employ the scan marker
feature. Use the UP/DOWN arrow keys to select the desired Trunk
Activity Search Time. This timer determines how long the radio will
stay on the control channel searching for voice activity before
scanning the next system. Valid entries range from 0 (zero) to 255
seconds in one-second increments.