User`s guide

161
Radio Wide Scan
Options
From the MAIN MENU, press F4, F3, F5 and then F8 to access this
screen.
This screen is used to customize the Channel Scan feature for specific
applications. Options and parameters that affect Radio wide,
Conventional and Trunking operations are available. Press Tab to
select the desired field, or press the desired function key (F1 - F10). If
a field is highlighted, use the UP/DOWN arrow keys to select the
desired choice or value.
Field Definitions
Nuisance Mode Delete Use the UP/DOWN arrow keys to enable/disable this feature. The
Nuisance Mode Delete setting allows the user to temporarily delete
from the scan list all non-priority channels that are constantly busy.
Such activity may cause the radio to be constantly locked onto a
channel.
Note: A channel deleted using this option will remain deleted
until scan is turned off. When scan is turned on, all channels
that were previously deleted will be replaced.
Priority Scan Alert Use the UP/DOWN arrow keys to enable/disable this feature. If this
option is enabled, the radio will audibly alert you in one of two ways
described below when it unmutes on a priority channel while
scanning:
❒ One beep is generated for the priority talkgroup/subfleet in a
Trunked scan list or for the first priority channel in a
Conventional scan list.
❒ Two beeps are generated for the second priority channel in a
Conventional scan list.
Rx/Tx Hold Time (sec) Use the UP/DOWN arrow keys to select the amount of time the radio
will remain on a channel after a message has been received/
transmitted before it begins scanning again. Valid entries range from
0 (zero) to 255 seconds in one-second increments.
DCEH
MOTOROLA Radio Service Software Use UP/DOWN Arrows to Select Choice.
ASTRO Model:
MAIN:CHANGE/VIEW:CONFIG:SCAN:OPTIONS
SCAN OPTIONS
------------
RADIO WIDE CONVENTIONAL
---------- ------------
Nuisance Mode Delete.......Enabled Carrier Detect Required....Enabled
Priority Scan Alert........Enabled Priority Chan Marking..... Enabled
Rx/Tx Hold Time (sec)............3 Monitor Hold Time (sec)..........6
HUB Suspends Scan..........Enabled Time Between Pri Samples (ms).6325
TRUNKING
--------
Failsoft Hold Time (sec).........6
System Search Time (sec).........1
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP EXIT