User`s guide

103
Low Battery Standby Chirp (sec) This field will be visible for Portables only. Use the UP/DOWN arrow keys
to make your selection or enter the desired value directly. This is the
length of time between successive low battery alert chirps. Valid
entries range from 30 to 930 seconds in 30-second increments. A
setting of Disabled (that is, the radio will not sound alarms when it is
idle, but the alarm will still sound at the end of each transmission if
the Low Battery Tx Chirp field is enabled.)
Low Battery LED This field will be visible for Portables only. Use the UP/DOWN arrow keys
to enable/disable this feature. If this field is enabled, a red Tx LED will
flash when a low battery condition is detected while the radio is
transmitting.
Rotary Alert This field will be visible for Continuous Rotary Control Mobile models only.
Use the UP/DOWN arrow keys to select the type of Continuous Rotary
Alert from among the following:
Out of Range Use the UP/DOWN arrow keys to select the desired type of Out of
Range indication. This field determines how the radio will indicate an
Out of Range condition on a Trunked system. When the radio can no
longer communicate with the base station, it can be programmed to
sound an out-of-range alert tone, display an out-of-range message, or
both. To disable this feature, set the field to No Indication.
Zero Level Audio Mute This field will be visible for Portables only. Use the UP/DOWN arrow keys
to enable/disable this feature. When this feature is enabled, the user
can mute all radio speaker activity by simply rotating the volume
control knob to a point less than the radio’s Minimum Volume setting.
Note: The Minimum Volume level is adjustable and can be
adjusted via the Minimum Volume level field.
Block Pending CA/PC Use the UP/DOWN arrow keys to enable/disable blocking of Pending
Call Alerts or Private Calls. When this feature is enabled, the radio will
ignore all successive Call Alerts (or Private Calls) after receiving a Call
Alert (or Private Call) with a different ID than the one which
originated the pending call.
Rotary Switch (Scan Prgm) This field will be visible for Portables only. Use the UP/DOWN arrow keys
to define the operation of the Channel Rotary during scan
programming when BOTH Zone and Channel selection are from the
radio menu (that is, the rotary is not used). The rotary can be used to
step through either channels or zones during scan programming. This
feature is applicable ONLY when both the Zone and Channel selections are
made from the radio menu.
Rollover Alert Turning the Rotary control past all programmed
channels in either direction will cause an alert tone
(beep).
Elec. Stop Turning the Rotary control past the first channel
position in either direction will cause an alert tone.
None Turning the Rotary control will cause no alert tones.